Hello
Does anyone have the cam specifications for :
1. Standard NA city
2. City T1
3. City T2
The specs for the T2r are already posted.
Thanks
Mark
Cam specifications
-
- Forum Regular
- Posts: 73
- Joined: Sun Feb 01, 2004 12:53 pm
- Location: Brisbane, Australia
- James
- Moderator / Donating Member
- Posts: 3092
- Joined: Wed Apr 09, 2003 1:59 pm
- Location: Putaruru
- Contact:
They are in the Manuals. If you dig them out it would be good if you posted them up here.
http://www.cityturbo.com/manuals/24_60PD100/06/09.html
Shows lobe sizes for a T1, cant see anything different for a T2 so might be the same.
http://www.cityturbo.com/manuals/02_60SA700/06/09.html
N/A City.
Just measure the base circle diameter on a standard cam and subtract from those measurements to get peak lifts. There are specs on the timings around somewhere but Im not sure where, you can inference them from the Mugen Cam specs in the infobase.
Are you getting a grind done? Its something I have been thinking about recently as its going to be very important to my high HP build.
Interesting that the Turbo has slightly more CVCC valve lift as well as main valve lift.
http://www.cityturbo.com/manuals/24_60PD100/06/09.html
Shows lobe sizes for a T1, cant see anything different for a T2 so might be the same.
http://www.cityturbo.com/manuals/02_60SA700/06/09.html
N/A City.
Just measure the base circle diameter on a standard cam and subtract from those measurements to get peak lifts. There are specs on the timings around somewhere but Im not sure where, you can inference them from the Mugen Cam specs in the infobase.
Are you getting a grind done? Its something I have been thinking about recently as its going to be very important to my high HP build.
Interesting that the Turbo has slightly more CVCC valve lift as well as main valve lift.
- James
- Moderator / Donating Member
- Posts: 3092
- Joined: Wed Apr 09, 2003 1:59 pm
- Location: Putaruru
- Contact:
Ah ha, found the cam timings,
http://www.cityturbo.com/manuals/43_60PD120/01/04.html
about half way down that page
http://www.cityturbo.com/manuals/43_60PD120/01/04.html
about half way down that page
You can also find the standard cam specs on the Tighe Cams site. I might be selling my cam which has a 946 grind on it if you are after one.
Who is online
Users browsing this forum: No registered users and 22 guests