I'm looking to sell off all the unneeded parts from my Project race car build.
Up for sale is an original clip in/removable style rear seat from my City T2.
It's trimmed in the standard velor blue & fluffy white, also has NO sign of sun fade or wear & tear.
I will host some pictures soon, otherwise seriously interested persons can request then to be emailed.
price can be negotiated depending on what you think the item is worth...
F/S: Original City T2 rear passenger seat <PICS UP>
- rustyhornet
- Forum Regular
- Posts: 94
- Joined: Fri Jul 15, 2005 8:30 pm
- Location: Adelaide, South Australia
F/S: Original City T2 rear passenger seat <PICS UP>
Last edited by rustyhornet on Fri Jan 04, 2008 2:33 pm, edited 1 time in total.
- rustyhornet
- Forum Regular
- Posts: 94
- Joined: Fri Jul 15, 2005 8:30 pm
- Location: Adelaide, South Australia
Pictures Up!
Open to reasonable offers, as I can't use once the roll cage goes in
shipping can be arranged!
- rustyhornet
- Forum Regular
- Posts: 94
- Joined: Fri Jul 15, 2005 8:30 pm
- Location: Adelaide, South Australia
Lads... The cage was made by a cams approved roll cage fabricator here in Adelaide.
It was custom made for my city T2, as nobody has ever bothered to make a roll-cage for one of these car here...
Measurements where taken for the design to be made & supplied as a "kit" for lack of better words.
All the tubes are pre bent & ruffly cut to length. This cost $950 alone.
Now I've got the task of cutting & notching the tubes to fit correctly together, followed by welding the lot in myself. Then submitting the photos & papers work to CAMS for approval.
To have the complete job done including welding, it was quoted at around $2600-3k
So are you still interested now!?
I could supply one of these "KITS" to you interstate, but you would NOT get any change out of $1000 (including shipping)
It was custom made for my city T2, as nobody has ever bothered to make a roll-cage for one of these car here...
Measurements where taken for the design to be made & supplied as a "kit" for lack of better words.
All the tubes are pre bent & ruffly cut to length. This cost $950 alone.
Now I've got the task of cutting & notching the tubes to fit correctly together, followed by welding the lot in myself. Then submitting the photos & papers work to CAMS for approval.
To have the complete job done including welding, it was quoted at around $2600-3k
So are you still interested now!?
I could supply one of these "KITS" to you interstate, but you would NOT get any change out of $1000 (including shipping)
- rustyhornet
- Forum Regular
- Posts: 94
- Joined: Fri Jul 15, 2005 8:30 pm
- Location: Adelaide, South Australia
- rustyhornet
- Forum Regular
- Posts: 94
- Joined: Fri Jul 15, 2005 8:30 pm
- Location: Adelaide, South Australia
Who is online
Users browsing this forum: No registered users and 25 guests